Motion Set; System Set (I) - Lorex SG21FD3044-161 Instruction Manual

NOTE: Some alternative brand PIR motion sensors have a default setting of N.C
(normally closed). In order to activate the alarm on such a PIR motion sensor, change
the setting to N.C
7.5

MOTION SET

This submenu allows you to enable / disable the Pixel-based Motion Detection function by
channel and set its Sensitivity level.
a) MOTION : Selecting [OFF] disables the Pixel-based Motion Detection function. Selecting
[OSD] will allow motion to trigger alarms, and the letters "MD" will appear on the screen
of the camera location where the motion is taking place. A third option, [OSD+BUZZER]
will display "MD" and emit a buzzer sound in the event that motion is detected.
b) CHANNEL : Select which channels will have the Pixel Motion Sensing feature activated.
The Sensitivity level can be set to zero for a channel, which will disable the Motion
Sensing ability for that channel.
c) SENSITIVITY : Select the sensitivity level by channel. Level 05 is the highest sensitivity,
Level 01 is the least sensitive. Level 00 deactivates Motion Sensing.
d) AREA : Select the area of the screen where the Pixel Motion Sensing feature will be
active. The digits below represent the area on the screen where motion is detected.
[00] - Whole screen.
[02] - Top right side of screen.
[04] - Bottom right side of screen.
00
7.6

SYSTEM SET (I)

This sub-menu allows you to configure various preferences on the system, related to Monitor
settings.
a) KEY BUZZER : When set to [Y], the system will make a sound when a key is pressed on
the remote control or on the main panel of the monitor.
b) LOSS BUZZER : When set to [Y], the system will make a sound when a camera
becomes disconnected.
c) QUAD LINE : Activates and deactivates the border line in Quad mode.
d) BLANK COLOR : Choose between blue, gray or black as the background screen color in
Menu Mode.
e) TITLE/TIME : Change the location of on-screen display for Time/Date and camera titles.
T/R/B/L represents Top / Right / Bottom / Left respectively. Therefore, for example, the
setting "TR/BL" would display the Title in the Top-Right corner of the screen, and the
Time in the Bottom Left corner.
f) PAN/TILT(CH1) : Activates Pan/Tilt mode to become accessible.
NOTE: if the PAN/TILT function is enabled, CH1 will not trigger when an external alarm
occurs.
g) ALARM OUT : Select the Alarm Out setting, which is defaulted to NO (Normally Open) for
triggering external devices.
[01] - Top left side of screen.
[03] - Bottom left side of screen.
[05] - Center of the screen.
01 02
03 04
16
05