Time / Date Set; Sequence Set; Title Set; Alarm Set - Lorex SG21FD3044-161 Instruction Manual

Enter the MENU screen by pressing the MENU button. Scroll through the 12 options by pressing
the UP and DOWN buttons. To enter a sub-menu, press the Enter button where the highlighted
scroll bar is located. To exit the Main Menu, scroll down to the Exit option and press the Enter
button.
NOTE: In sub menu of the Main Menu, you can exit the Menu mode by selecting Exit, or you
can return to the Main Menu by selecting Return.
NOTE: The Menu is exited automatically after 60 sec of inactivity.
7.1

TIME / DATE SET

This submenu allows you to change the Time and Date displayed on the monitor, and also
program the information you'd like to appear in the On-Screen Display.
a) DISPLAY : Selecting [Y] enables on screen display of the date & time. Selecting [N]
hides this information.
b) TIME : Change the time (24 hour clock)
c) DATE : Change the date.
d) DATE FORMAT : There are three formats to display the date:
MM / DD / YYYY : for U.S.A.
YYYY / MM / DD : for Asian countries.
DD / MM / YYYY : for European countries.
7.2

SEQUENCE SET

This submenu allows you to select how long you'd like each channel to appear on-screen
before automatically switching to the next channel in Sequence mode. The Dwell Time is
0-59 seconds selectable for each of the 8 channels and for Quad A / QUAD B mode.
NOTE: Channels without a camera, a Video Loss, or a Dwell Time of zero will be
skipped in sequencing.
7.3

TITLE SET

This submenu allows you to change the title of each camera location (up to 8 characters), or
remove the titles from the on-screen display.
a) DISPLAY : Selecting [Y] will enable the camera titles to appear in the on-screen display.
Selecting [N] will remove all titles from appearing in the on-screen display.
b) CH 1 - 8 : Change the titles of each individual camera.
7.4

ALARM SET

This submenu allows you to enable / disable the camera's PIR Alarm function by channel.
a) ALARM : Selecting [OFF] disables PIR motion detection from triggering any alarm.
Selecting [OSD] will allow alarms to be triggered, and the letters "AL" will appear on the
screen of the camera location where the alarm is taking place. A third option,
[OSD+BUZZER] will both display "AL" and emit a buzzer sound in the event of an alarm.
b) CH 1-8 : Set the length of alarm time for each channel between 1~59 seconds.
Additionally, you can select the Alarm Input. The default setting is OFF - to activate the
Alarm on a camera, change the setting to N/O (Normally Open), N/C (Normally Close).
15