Appendix #2 - Connection To A Pir Motion Sensor; Pir Motion Sensors - Lorex SGQ4160 Instruction Manual

APPENDIX #2 – ALARM BLOCK CONNECTION
Wires from the PIR Motion Sensors must be soldered to the terminal of the 9 Pin Alarm Connector.
Each PIR Sensor connects via 2 wires: 1 to a specific Channel and the other to the Ground input.
For descriptions of each contact on the 9 Pin Connector of the Quad Processor, please refer to Appendix #4.
9 PIN Alarm Connector
7
8
to PIR MOTION SENSOR
2
3
11

PIR Motion Sensors