Cleaning, Maintenance, Storage, Disposal; Cleaning; Maintenance; Maintenance Plan - Zipper Mowers ZI-STE2000IV User Manual

14

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Always stop the machine and let it cool down before carrying out any maintenance work
WARNING:
Lack of maintenance or improper maintenance and repair before using the machine can result in serious
injury or death! Take therefore the safety rules, operating and maintenance instructions very seriously.
Repairs only by qualified staff!
NOTE:
Prevent unintentional commissioning of the machine by interrupting the fuel supply (ON-OFF switch
in position "OFF") as well as interrupting the ignition spark (remove spark plug cap of spark plug).
14.1

Cleaning

Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe operation.
NOTE: The use of solvents, aggressive chemicals or scouring agents can cause damage to the plastic
parts of the machine!
Thus, when cleaning, use only water and, if necessary, mild detergents.
• We recommend cleaning the machine immediately after each use.
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a moist cloth and some soft soap or blow it with compressed air at
•
low pressure.
• Take care that any water enters the interior of the machine.
14.2

Maintenance

The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects that
could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
• Regularly check the perfect and legible condition of the warning and safety labels of the
machine.
Use only proper and suitable tools.
•
Use only original spare parts recommended by the manufacturer.
•
14.2.1

Maintenance plan

The type and degree of machine wear depends to a large extent on the operating conditions. The following
intervals apply when the machine is used within the technical limits:
(1) Interval can vary
according to the air quality
(2) Only by specialists!
Control the
level
Engine oil
Change
Control
Air filter
Change
Control
Spark plug
Change
Fuel tank and
Clean
fuel filter
Fuel pipe Control
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
WAR N I N G
and secure it against unintentional commissioning.
Prior to (for new
each machine)
start after first
Month or 20
operation
hours
X
X
X
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Every 3 Every 6
months or months
every 50 or every
operation 100
hours operatio
n hours
X
X (1)
X
X (2)
Every 12 Every 2
months or years
every 200
operation
hours
X
X (2)
38
ZI-STE2000IV