Safety Precautions - S&C TripSaver II Operation Manual

1 . QUALIFIED PERSONS. Access to TripSaver II
Cutout-Mounted Reclosers and the magnet tool
must be restricted only to qualified persons . See
the "Qualified Persons" section on page 2 .
2 . SAFETY PROCEDURES. Always follow safe
operating procedures and rule .
3 . PERSONAL PROTECTIVE EQUIPMENT. Always
use suitable protective equipment, such as rubber
gloves, rubber mats, hard hats, safety glasses, and
flash clothing, in accordance with safe operating
procedures and rules .
4 . SAFETY LABELS AND TAGS. Do not remove or
obscure any of the "DANGER," "WARNING,"
"CAUTION," or "NOTICE" labels and tags . Remove
tags ONLY if instructed to do so .
DANGER
The TripSaver II Cutout-Mounted Recloser operates at high voltage . Failure to observe
these precautions will result in serious personal injury or death .
Some of these precautions may differ from your company's operating procedures and
rules . Where a discrepancy exists, follow your company's operating procedures and rules .
5 . ENERGIZED COMPONENTS. Always consider all
parts live until de-energized, tested, and grounded .
6 . OPERATING TOOLS. To close a TripSaver II
Cutout-Mounted Recloser, use a conventional
insulated hotstick or S&C Universal Pole and Pole
Extension fitted with a Talon™ Handling Tool or
distribution prong . To open a TripSaver II Cutout-
Mounted Recloser, use Loadbuster®—The S&C
Loadbreak Tool attached to a conventional insulated
hotstick or S&C Universal Pole .
The magnet tool must only be used when attached
to an insulated hotstick .
MAINTAINING PROPER CLEARANCE. Always
7 .
maintain proper clearance
components.
S&C Instruction Sheet 461-507

Safety Precautions

from energized
5