Table of Contents
Advertisement
Intrusion
If any target intrudes into the pre-defined region longer than the set duration, the alarm will
be triggered.
Region Entrance
If any target enters the pre-defined region, the alarm will be triggered.
Region Exiting
If any target exits the pre-defined region, the alarm will be triggered.
4. Draw the detection rule.
Rule Type
Line Crossing
Intrusion
Region Entrance
and Region Exit
5. Set other parameters for the rule.
Detection Target
You are recommended to select the target as Human & Vehicle. In distant view, the device
cannot classify the target with pixels less than 10*10. The target will be recognized as human
directly. So the selection of this item will not trigger false alarm or missing alarm.
Background Interference Suppression
Eliminate the environment interference to reduce the false alarm. For example, the false
Thermal & Optical Bi-spectrum Network Camera
How to Draw and What Parameters to Set
1. Click
to draw a line in the live view.
2. You can drag end points of the line to adjust the position and
length.
3. Set the crossing direction. Bidirectional, A-to-B, or B-to-A are
selectable.
4. Set Sensitivity. The higher the value is, the easier the target can be
detected.
1. Click
to draw an area in the live view. Right click the mouse to
finish drawing.
2. Set Duration. When a target intrudes into the set area and stays in
the area for more than the set duration, the device triggers an
intrusion alarm.
3. Set Sensitivity. The higher the value is, the easier the target can be
detected.
Click
to draw an area in the live view. Right click the mouse to finish
drawing.
Target that enters or exit the set area triggers the region entrance or
region exit alarm.
20
Advertisement
Table of Contents
