Table of Contents
Advertisement
Connection Settings
Ethernet Interface
Usually set to Any but can be changed to use only a specific Ethernet card with the
SERIP-100 device server.
IP Address
Enter here the IP address of the SERIP-100 device server. This value is pre-set to be
the default IP address 169.254.0.10 of the SERIP-100 device server
Port
Each serial port on the same serial device server must use a different TCP or UDP
port number.
Connect on
It is possible for the redirector process to connect depending on the status of a
modem control line of the virtual COM port. This could for example be set to DTR
so the connection is only established when the application opens the COM port and
disconnected when it closes the COM port.
Reconnection Delay
Delay time between connection attempts. Setting is only available in client mode.
Operating Mode
Mode
This mode must match the opposite of the mode setting of the SERIP-100 device
server. The default is TCP client.
Keep Active Period
Can only be activated in Telnet modes. Sends NOP Telnet commands to monitor the
health status of the connection and avoid disconnection due to inactivity.
Map Connection Status to
The TCP connection status can be indicated on one of the modem status lines of
the virtual COM port. That way the application software using the COM port knows
whether a connection is established or not.
UMSERIP100-2201
Virtual COM port redirector
43
Advertisement
Table of Contents
