Table of Contents
Advertisement
• The shield must not be connected to the GND pin.
To connect the SERIP-100 to a PC (Personal Computer) or any other device with data
terminal equipment (DTE) pinout you need a null-modem or cross-over cable.
Connecting Ethernet
The following table describes the 10BASE-T Ethernet RJ-45 connector pinout:
Pin
1
1
2
3
4
5
6
7
8
Table 3.4: Ethernet connector pinout
• We recommend to use Category 5 UTP network cable.
• Maximum cable length is 100 m (3000 ft).
UMSERIP100-2201
Signal
Function
TX+
Non-inverting transmit signal
TX-
Inverting transmit signal
RX+
Non-inverting receive signal
Internal termination network
Internal termination network
RX-
Inverting receive signal
Internal termination network
Internal termination network
Installation
15
Advertisement
Table of Contents
