Configuring Ethernet And Ip; Ethernet And Ip Settings Page - Proconx SERIP-100 User Manual

Configuring Ethernet and IP

Select the Configuration→Ethernet & IP sub-menu from the menu bar to open
the Ethernet and IP settings which are shown below:
Figure 5.5: Ethernet and IP settings page
The following Ethernet parameters are shown:
MAC Address
The device' unique MAC address. This number is hard coded and cannot be changed.
The following Internet protocol (IP) settings can be entered:
DHCP Client
Select Enabled to have the IP address assigned via DHCP. When enabling this option
it is important to have a reliable DHCP server available in the network at all times.
The SERIP-100 will not communicate without an IP address. A missing IP address is
indicated with a distinct LED diagnostic code.
IP Address
The static IP address assigned to this device if DHCP is not used. This IP address is
different to the IP address assigned through DHCP.
Subnet Mask (also known as network mask)
If you have a router, enter the subnet mask for the segment to which this device is
attached.
Gateway Address
If your network segment has a router, enter its IP address here. Otherwise leave the
address as 0.0.0.0.
Once you click Save the new settings are stored and applied instantly. Existing TCP/IP
connections to the device are terminated and must be re-established using the new IP
address.
UMSERIP100-2201
Web browser based management
25