Table of Contents
Advertisement
Reset to factory defaults
This alarm indicates that the device' configuration data was reset to factory defaults.
The device requires re-commissioning.
Ethernet status
The Ethernet Status page shows status and statistics about the Ethernet traffic.
These values provide valuable information used to troubleshoot network problems. This
page is automatically updated every 5 seconds.
Figure 5.3: Ethernet status page
This page shows accumulated readings since the SERIP-100 was last activated or
reset. If power to the SERIP-100 is lost, all cumulative values are reset to zero.
The following statistics are maintained:
Connections
A counter that increments each time a client or server connects to the gateway.
Packets Received
A counter that increments each time an inbound message is successfully received.
Packets Sent
A counter that is incremented each time an outbound message leaves.
Connection Errors
This counter applies to client modes only. It is incremented each time a connection
attempt failed.
Receive Errors
Number of errors while receiving an inbound packet from the network.
Transmit Errors
Number of errors while sending an outbound packet to the network.
Resource Errors
Counter of low memory resource situations.
The cumulative diagnostic data is reset when the device is power cycled or reset. The
data is also reset by pressing the Clear Counter button.
UMSERIP100-2201
Web browser based management
23
Advertisement
Table of Contents
