To perform a remote restart, click on the Configuration sub-menu and then click on
the Restart menu entry. This will open the device restart page as shown below:
Figure 5.10: Restart device page
Click on the Restart button to perform a restart of the device. The restart is confirmed
with the following notification:
Figure 5.11: Restart confirmation page
Please allow a few seconds before continuing working with the device as it has to fully
start-up first, before being able to respond to further web browser requests.
After a remote restart a Watchdog reset alarm is shown on the device' home page.
This is a side-effect of the remote restart procedure and the alarm shall be ignored
and cleared.
Backup and restoring of configuration settings
The SERIP-100 allows configuration settings to be uploaded onto a PC.
This is a beneficial for archiving purposes but also allows easy deployment of similar
devices by the means of loading settings from a previously stored reference device.
UMSERIP100-2201
Web browser based management
29