Table of Contents
Advertisement
Chapter 5. Web browser based management
The SERIP-100 incorporates an embedded web server. This allows you to connect to the
device and monitor and configure it using a web browser. Most browsers should work,
provided they support JavaScript. We recommend Internet Explorer 6.0 or higher.
Connecting to the SERIP-100
Once you made sure that your PC is configured to be on the same subnet as the
SERIP-100, start your web browser. In the address box, type the IP address of your device
(169.254.0.10 is the default), and then press Enter. (See Chapter 4, Ethernet & IP
configuration)
The web browser will establish communication with the embedded web server and an
overview page similar to the following picture will appear:
Figure 5.1: Device management and configuration via the web browser
Gateway IP address
Main menu
Configuration sub-menu
Information area
Use the menu bar shown on the left side to navigate the different pages.
UMSERIP100-2201
Web browser based management
21
Advertisement
Table of Contents
