Table of Contents
Advertisement
Checking the print results
When the spooler is disabled
After printing, the job ID and print results are returned to the application. Also, when printing cannot be per-
formed, the job ID, print results, and error code are returned.
When the spooler is enabled
• When print data cannot be spooled:
[JobID, Print result = false, Error code = EX_SPOOLER (spooler stopped)] is returned to the application.
• When print data can be spooled:
After spooling the print data, [JobID, Print result = true] is returned to the application. Printing is not per-
formed at this point. Make an inquiry from the application to this product to confirm if printing was per-
formed.
Checking the print results from the application
If inquired of print result from the application, the product returns the following information.
• Printing succeeded:
• Printing succeeded:
• Printing or print forwarding:
• When this product is turned off, data in the spooler and the log storage area is cleared. For
detail, see
• When printing cannot be performed with this products spooler or print forwarding, the print
data is cleared. If printing has not been completed when checking in the application, we rec-
ommend reprinting.
Setting Items
Spooler and forward printing are configured on the same page.
Setting
Enabling / Disabling ePOS-Device Service
Web service
(page
82)
Print forwarding
(page
88)
[JobID, Print results = true]
[JobID, Print result = false, Error code = Printer status]
[JobID, Print result = false, Error code = Printing]
"TM-DT Software Specification" on page
• Enabling ePOS-Device Service
(page
54)
• Enabling spooler
• Retry count
• Forwarding message
• Print forwarding route
Chapter 5 TM-DT Software System Development
104.
Items
5
62
Advertisement
Table of Contents
