Siemens SIPROTEC 7SJ61 Manual page 371

No system interface
IEC-Protocol, electrical RS232
IEC-Protocol, electrical RS485
IEC Protocol, Optical, 820 nm, ST Connector
Profibus FMS Slave, electrical RS485
Profibus FMS Slave, Optical, Single Ring, ST-Connector
Profibus FMS Slave, Optical, Double Ring, ST-Connector
For further interface options see Additional Information in the following
Additional information to further system interfaces (Rear Side, Port B)
PROFIBUS DP Slave, RS 485
Profibus DP Slave, 820 nm, Optical Double Ring, ST–Connector
Modbus RS 485
Modbus, 820 nm, Optical, ST–Connector
DNP3.0, RS 485
DNP3.0, 820 nm, Optical, ST–Connector
IEC 60870-5-103 Protocol, redundant RS485
IEC 61850, Ethernet electrical, double, RJ45–connector (EN 100)
IEC 61850, Ethernet optical, double, ST-connector (EN 100)
1)
Cannot be delivered in connection with 9th digit = "B". If the optical interface is required you must order the
following: 11th digit = 4 (RS 485) and in addition, the associated converter
2)
Cannot be delivered in connection with 9th digit = "B".
Converter
SIEMENS OLM
SIEMENS OLM
1)
The converter requires an operating voltage of 24 V DC. If the available operating voltage is > 24 V DC the
additional power supply 7XV5810–0BA00 is required.
No DIGSI interface at rear side
DIGSI/Modem, electrical RS232
1)
DIGSI/Modem/RTD-Box
1)
DIGSI/Modem/RDS box
1)
RTD-box 7XV5662–*AD10
2)
If you want to run the RTD-Box at an optical interface, you need also the RS485–FO–converter
7XV5650–0*A00.
SIPROTEC, 7SJ61, Manual
C53000-G1140-C210-1, Release date 02.2008
System Interface (Rear Side, Port B)
2)
2)
2)
1)
1)
DIGSI/Modem Interface (Rear Side, Port C)
, electrical RS485
, optical 820 nm, ST-connector
1)
1)
1)
2)
Order No. Use
6GK1502–2CB10 For single ring
6GK1502–3CB10 For double ring
2)
A.1 Ordering Information and Accessories
Appendix
Position
11
0
1
2
3
4
1)
5
1)
6
9
Supple-
mentary
+ L 0 A
1)
+ L 0 B
+ L 0 D
2)
+ L 0 E
+ L 0 G
2)
+ L 0 H
2)
+ L 0 P
+ L 0 R
2)
+ L 0 S
Position
12
0
1
2
3
371