Table of Contents
Advertisement
Replacing the light bulb
connected.
›
Insert the bulb holder into the light and snap into
place.
NOTICE
Risk of damage to the electrical system!
Make sure that no cables are trapped when insert-
▶
ing the holder into the lamp.
Insert and fix the lamp
›
Insert the connector into the light until it clicks into
place.
›
Press in the slightly pulled out latch on the connec-
tor.
Lighting, windscreen wipers and washers ›
›
Take out the lamp.
›
Pull
some-
the lock A
what out of the plug.
›
Press the safety button
and pull out the plug.
›
Unlock and remove the
lamp holder
.
A
›
Change the bulb in the
socket.
›
The base for the bulb
in the turn signal light
is marked with
.
The base for the bulb
in the reverse light is
marked with
.
›
Check that the con-
nector
is securely
A
›
Insert the lamp with the strips
in the body and push it in carefully until it stops.
NOTICE
Risk of damage to the electrical system due to water
ingress!
Make sure that the seal is used correctly when in-
▶
stalling the lamp
.
C
NOTICE
Risk of damage to the electrical system!
Make sure that the lines between the lamp and the
▶
body are not pinched when the lamp is inserted.
›
Screw on the lamp.
›
Close and lock the cover cap.
Interior lighting
service
Operation of the lighting
turn on
Back lighting
Turn off
Reading lights
/ Center position of the switch
off
Automatic switch on
The light switches on when one of the following
events occurs.
The vehicle is unlocked.
▶
One of the doors is opened.
▶
The ignition key is removed (vehicle without start-
▶
er button).
The ignition is switched off (vehicle with starter
▶
button).
Automatic switch off
The light switches off when one of the following
events occurs.
The vehicle is locked.
▶
The ignition is switched on.
▶
About 30 seconds after all the doors have been
▶
closed.
Interior lighting
55
in the grooves
A
B
Automatic
switching on and
Advertisement
Table of Contents
