Table of Contents
Advertisement
›
Take out the key bit.
Switch off/on front passenger airbag
›
to turn on the key switch carefully into position
rotate.
›
Remove the key bit from the slot.
›
Close the passenger door.
›
Turn on the ignition and check that the front pas-
senger airbag indicator lights are lit up.
Indicator lights
After switching on the igni-
▶
tion, the two indicator lights
light up briefly.
If the system is OK, the two
▶
indicator lights go out.
One of the indicator lights then lights up again de-
▶
pending on the position of the key switch.
lights up - front passenger airbag switched
off
lights up 65 secs after the ignition is
switched on – passenger front airbag
switched on
Troubleshooting
Key switch for airbag deactivation is faulty
flashes together with
The front passenger airbag will not be de-
ployed in the event of an accident!
›
Have the airbag system checked immediately by a
specialist company.
Lighting, windscreen wipers and washers ›
›
Switch off the ignition.
›
Open the passenger
door.
›
Insert the key bit into
the slot in the key
switch as far as it will
go.
›
to Switch off the key
switch carefully into
position
rotate.
Lighting, windscreen wipers and
washers
Exterior lighting
functionality
Unless otherwise stated, the light works when the
ignition is switched on.
Daylight running lights
The daytime running lights illuminate the area in
front of the vehicle.
In vehicles for certain markets, this also provides
lighting for the rear area of the vehicle.
Functional conditions
✓ The lights switch is in position ,
Automatically switch the low beam on/off
The low beam is automatically switched on or off de-
pending on the lighting conditions.
Functional conditions
✓ The light switch is in the
The automatic driving light switch is activated by the
symbol lighting up
displayed in the light switch.
Automatically switch the low beam on/off when it
rains
Functional conditions
✓ The light switch is in the
✓ The function is activated.
✓ The windscreen wipers are switched on for lon-
ger than 30 seconds.
The automatic driving light switch is activated by the
symbol lighting up
displayed in the light switch.
Full LED front headlights
When the light switch is in position
lights provide the best possible beam of light in front
of the vehicle.
The Dynamic cornering light function ensures the
best possible illumination of the curve area.
CORNER function
The CORNER function is intended for turning or ma-
noeuvring (e.g. when parking).
The function illuminates the vicinity of the vehicle
front in the direction of travel.
Functional conditions
✓ The turn signal is switched on or the front wheels
are steered sharply.
✓ The low beam is switched on.
✓ The fog lights are not switched on.
✓ The driving speed is lower than 40 km/h.
Exterior lighting
49
or
.
position.
position.
, the head-
Advertisement
Table of Contents
