Table of Contents
Advertisement
44 / 134
Customize and modify the single reading time
Example: To set the limit time of a single code reading to 1500ms, you can set it
according to the following steps:
1. Scan the "Enable Setting code (you don't need to scan when it is turned on);
2. Scan the setting code of "Customize and modify single reading time";
3. Scan the "1", "5", "0" and "0" setting codes in "Appendix-Data Code" in turn;
4. Scan the "Save" setting code in "Appendix-Save and Cancel Settings";
5. Scan the "Disable Settings code.
Manual reading mode-the same barcode reading delay
In order to avoid the same barcode being read multiple times in a short time in the
trigger mode, you can request the reading module to delay the set time in this mode
before allowing the same barcode to be read.
Advertisement
Table of Contents
