ADAPT Parasol b
ProSelect
Sizing and hardware configuration
This is not a manual describing how ProSelect works, the page is just meant to point out some things in particular that
are worth considering.
1. As ADAPT Parasol is always supplied with some sort of control this is included as an accessory from the outset.
Clicking on the button takes you to the configuration page for the control.
2. Calculations can be done for min/occupancy/max airflow. However, only the current selection is shown on the
calculation page.
3. Nozzle settings can be made just like for a standard Parasol to influence the airflow and direction, but it should be
remembered that at the same time you influence the product's minimum and maximum flow.
4. The min and max positions are highlighted in grey as they cannot be entered as the occupancy flow. This is because
the min/max is directly dependent on the selected nozzle setting. HOWEVER, in the context of these flows you can
then enter the desired Min occupancy and max flow in software.
26
Swegon reserves the right to alter specifications.
3
2
4
25/11/2014
1
www.swegon.com