Installing Memory - Lexmark Optra C710 Setup Manual

Installing
memory
Note:
Memory options
designed for other Lexmark
printers may not work with your
printer. Refer to the User's Guide
for more information.
Memory connectors
Resident Code Card
DO NOT REMOVE card if present
Note:
Your printer may not
have a Resident Code Card.
Your printer comes with at least 32MB already installed.
(Some printer models may have more standard memory.)
You can purchase many different memory options from
Lexmark for the three memory slots in your printer. The
maximum amount of usable memory is 384MB. Make sure
you use SDRAM DIMM memory cards that meet the fol-
lowing criteria:
– 100 MHz or greater
– 100 pin
– 4K refresh rate
– unbuffered, non ECC
– x32
– 3.3V
If you need to remove a memory card first, see "Removing
a memory card" on page 13.
To install optional memory:
1
Complete the steps "Removing the rear cover and
EMI shield" on page 7 if the rear cover is still
installed.
2
Locate the memory connectors on the system
board as shown.
Each connector can support either a printer memory
card or a flash memory card.

Installing memory

9