Lexmark Optra C710 Setup Manual page 103

10
11
12
AppleTalk
7
See if the network printer shows up in
MarkVision.
– If it doesn't, the print server may have down-
level firmware.
– If it does but you still cannot print, try removing
then re-adding the Lexmark Network Port on the
printer object.
8
Reset both the print server and the printer.
9
If possible, shut down Windows NT Server and
restart the server. There could be a spooler
problem that requires a restart.
Uninstall, then reinstall MarkVision. During the
reinstallation, select only the network protocols
you actually use (for example, TCP/IP). This also
helps MarkVision run faster.
Try printing again.
If you are still having trouble, contact Lexmark for
help at 1-800-LEXMARK (1-800-539-6275) or on the
World Wide Web at http://www.lexmark.com.
1
Make sure the AppleTalk protocol is turned on
(activated) in the print server. To find out, print a
network setup page and look in the paragraph
under AppleTalk.
2
Look at the network setup page again and notice
the AppleTalk name and the AppleTalk zone for
the printer.
3
Make sure you are looking at the correct zone in
the Macintosh Chooser. The zone must be the
same one as listed on the setup page.
99
AppleTalk