Lexmark Optra C710 Setup Manual page 95

Note:
If you are using
Windows NT Server 4.0 or later
and running TCP/IP , you can use
Network Plug and Print to
automate your printer setup
process.
Note:
For details on installing
the necessary software, look on
the Drivers, MarkVision, and
Utilities CD . Click View
Documents and look for the
MarkNet link.
Set up to print
There are many ways to send a print job including FTP,
TFTP, LPR/LPD, point-to-point (LexIP), and various
queue-based methods. Instructions for two of the methods
follow.
Print to a queue on a Windows NT server
This section explains the setup for queue-based printing
where network users print to a queue defined on a
Windows NT server. The print server services this queue.
To use this method, you must have at least one server
running Windows NT Server software and TCP/IP.
The following instructions apply to Windows NT Server
Versions 4.0 and later.
1
Install the TCP/IP software component on the
server that contains the print queue. This software
is necessary to establish the link between the
MarkNet print server and the queue. Look on the
Drivers, MarkVision and Utilities CD for the
software. (Hint: Do a custom install to add
network support, and select TCP/IP.)
2
Set up a print queue on the server. Do this by
creating a printer object in the usual way. (Hint:
Start, Settings, Printers, Add Printer.)
a
When prompted, select My Computer (not
Network printer server).
b
Click Add Port.
c
Select Lexmark Network Port, and then click
New Port. Follow the instructions on the
screen.
d
Share the queue.
3
Set up your Windows 95, Windows 98, or
Windows NT clients in the usual way. (Hint: Start,
Settings, Printers, Add Printer.)
Configuring and printing
91