Table of Contents
Advertisement
en Accessories
Accessories
Baking tray
Glass scraper
6.1 Information on accessories
Some accessories are only suitable for certain types of
heating.
Microwave accessories
The wire rack that is supplied is only suitable for opera-
tion solely using the microwave.
Baking trays, e.g. the universal pan or the baking tray,
may create sparks and are not suitable.
Observe the information about the microwave.
6.2 Locking function
The locking function prevents the accessories from tilt-
ing when they are pulled out.
You can pull out the accessories approximately halfway
without them tipping. The accessories must be inserted
into the cooking compartment correctly for the tilt pro-
tection to work properly.
6.3 Sliding accessories into the cooking
compartment
Always slide the accessory into the cooking compart-
ment the right way round. This is the only way to en-
sure that accessories can be pulled out approximately
halfway without tipping.
1.
Turn the accessories so that the notch
rear and is facing downwards.
2.
Insert the accessory between the two guide rods for
a shelf position.
14
Wire rack
Baking tray
E.g. univer-
sal pan or
baking tray
3.
To place the accessory at shelf positions with pull-
out rails, pull out the pull-out rails.
Wire rack
or baking
is at the
tray
Note: Gently push the pull-out rails back into the
cooking compartment.
4.
Push the accessory all the way in, making sure that
it does not touch the appliance door.
Note: Take any accessories that you will not be using
out of the cooking compartment while the appliance is
in operation.
6.4 Other accessories
You can purchase other accessories from our after-
sales service, specialist retailers or online.
You will find a comprehensive range of products for
your appliance in our brochures and online:
siemens-home.bsh-group.com
Use
¡ Tray bakes
¡ Small baked items
Only use the glass scraper to clean the cam-
era lens.
Insert the wire rack with the open
side facing the appliance door and
the curved lip facing downwards.
Slide the tray in with the sloping
edge towards the appliance door.
Place the accessory so that it is in-
serted on the rear stop of the pull-out
system.
Advertisement
Table of Contents
