JMA MULTICODE Manual page 51

After having erased the Flash memory of the machine a process bar will appear with the following
The updating process will take 30 minutes Once the progress bar has reached its end. A message will appear for us
to switch the machine off and on.
After the downloading process has finished, the above message appears, we can exit the "JMAKeyPro"
application pressing the button END (F). We switch off the Multicode machine and then switch it on again, we will
see the green diode flash, that is because the firmware program is updating. This is normal and the process will take
from 5 to 10 minutes, until the diode becomes steady green, at that moment the Multicode is prepared to enter the
application again and continue cutting keys.
51