Update Firmware - JMA MULTICODE Manual

10.7 UPDATE FIRMWARE

The Firmware updating process is automatic, because when the program starts and connects to the Multicode it
checks the version of the same and if it is not adequate it jumps to the updating window.
Access to this same window can be obtained through "JMAKeyPro" Adjustments and clicking on the part of updating.
Settings Update firmware
NOTE: It is only recommendable to make the update when it jumps to a later or higher version of the software. It is
very important not to disconnect the machine until finishing the downloading process.
The updating process is very simple once we are in the following updating screen, we press ACCEPT and the process
starts automatically. The green diode of the machine will start to flash and will show us the following message:
50