Default Command - Lexmark C910 Reference Manual

Using the DEFAULT command to modify any of these variables forces a write to flash
or disk if resource collection mode is set to On before the command is executed. The
DEFAULT command causes a PJL Reset.
To determine which variables your printer supports, see Table B-7: "Printer Unique
LRESOURCE Variables" on page B-15.
Table 3-9: Printer Unique LRESOURCE Variables
Variable Function
LDESCRIPTION Macro or Symbol Set
Description
(DEFAULT only)
LRWLOCK Read/Write Lock (password)
for an entire device or a
(DEFAULT only)
particular file on the device
Selections
"alphanumeric string"
1
The description is limited to 16 characters and must
be enclosed in double quotes. If more than 16
characters are specified by the DEFAULT command,
the first 16 characters are used and a PJL parser
warning is issued.
The DINQUIRE command can be used to query the
file description. The description is returned in the
response.
"alphanumeric string"
This variable can be used with other PJL commands:
2

• DEFAULT command

The Read/Write password is limited to eight
characters. If more than eight characters are
specified by the PJL DEFAULT command, the
password is truncated and a PJL warning is
issued.
If a null (" ") password is given, password
protection is removed from the specified device or
file.
• DINQUIRE or INQUIRE commands
Use these commands to determine if a password
has been specified for a device or specific file. The
response is one of the following:
NOTSET
SET
EXPIRED
The LDECLARE command can be used to
temporarily unlock access to a device or particular
file. See "File and Device Protection Commands" on
page 3-93 for additional information about using
passwords on these devices.
3-53
The password has not been set or
has been reset to zero.
The password is defined and active.
The password is reset to zero (flash
memory only).
PJL
Factory Default
NULL
(no description)
NULL
(no password)
NOTSET