Image Tool; Introduction - Realtek Ameba-ZII DEV User Manual

2.5.3.1 Initiate Flash Download
Once the JLink GDB server is set up as per the instructions given before, perform the following steps to
initiate the flash download.
1. Proceed back to the previous terminal where the SDK was made, without closing the terminal from
which GDB server is running
2. Run the command "make setup GDB_SERVER=jlink or pyocd" to select GDB Server.
3. Run the command "sudo make flash"
4. If the flash download is successful, the following log will be printed
2.5.3.2 Debug
After a successfully downloading, user can debug with pyOCD + DAPLink enabled HDK or using
JLINKGDBServer + JLINK by following command
"make debug_tz"
Before using "make debug_tz", "make setup GDB_SERVER=jlink or pyocd" to select GDB Server is
necessary.
3

Image Tool

3.1

Introduction

This chapter introduces how to use Image Tool to generate and download images. As show in Figure 3-1, Image Tool
has two menu pages:

Download: used as image download server to transmit images to Ameba through UART.

Generate: contact individual images and generate a composite image.
Please download the 'PG Tool Release Package' and browse the image tool document 'UM0503'.
Note: If you need to download code via external uart, must use
Application Note All information provided in this document is subject to legal disclaimers.
21
FT232 USB To UART dongle.
Ameba-ZII Application Note
© REALTEK 2018. All rights reserved.