Table of Contents
Advertisement
2. Open installation location of 'JLink_V640' and run "JLinkGDBServer.exe" to check connection.
3. Make sure the configuration is fine and click 'OK'.
4. Check if the below information is shown properly.
Note: If J-Link GDB Server is unable to detect the device, try re-connecting the wires and re-open 'JLinkGDBServer.exe' may
solve the problem.
Application Note
Figure 2-2 J-Link Setup Interface
Figure 2-3 J-Link GDB server UI under Windows
Figure 2-4 J-Link GDB server connect under Windows
All information provided in this document is subject to legal disclaimers.
13
Ameba-ZII Application Note
© REALTEK 2018. All rights reserved.
Advertisement
Table of Contents
Need help?
Do you have a question about the Ameba-ZII DEV and is the answer not in the manual?