Table of Contents
Advertisement
INSTALLATION
Before you install the cooktop, make sure that
• The work surface is square and level, and no structural members interfere with
space requirements. Work surface to be made of heat-resistant material. Work
surface material thickness should be at least 30mm thick.
• If the cooktop is installed above an oven, the oven has a built-in cooling fan. Both
appliances generate a lot of heat during operation.
• The installation will comply with all clearance requirements and applicable
standards and regulations. A minimum of 50mm space shall be preserved around
the cutout opening for installation and use of larger cookware.
• A suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
• The isolating switch must be of an approved type and provide a 3mm air gap
contact separation in all poles (or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).
• The isolating switch will be easily accessible to the customer with the hob
installed.
• If any doubts regarding installation requirements you may consult local building
authorities and current by-laws.
• Use of heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the
wall surfaces surrounding the cooktop is recommended.
• Cut out the work surface according to the sizes shown in table below.
Warning: The work surface material must use the impregnated wood or other
insulated material.
L(mm)
BCT60INFZ
W(mm)
590
520
H(mm)
D(mm)
58
54
27
A(mm)
B(mm)
560
490
X(mm)
50 min.
Advertisement
Table of Contents
