Connecting The Stereo Port Framelock Cable; Figure 6-4 Sun Xvr-1200 Graphics Accelerator Stereo/Framelock Connector - Sun Microsystems XVR-1200 Installation And User Manual

Connecting the Stereo Port Framelock
Cable
Cable the Sun graphics accelerators to be framelocked before configuring your
system for framelock (described in "Configuring Graphics Accelerators for
Framelocking" on page 50).
1. Locate the master Sun XVR-1200 graphics accelerator I/O backplate on the rear of
your system and its stereo/framelock DIN7 connector (
FIGURE 6-4
2. Connect the framelock cable master connector to the stereo/framelock DIN7
connector (
3. Connect the slave cable connector to a slave Sun XVR-1200 graphics accelerator
stereo/framelock DIN7 connector.
4. If you are synchronizing additional Sun XVR-1200 graphics accelerators,
a. Connect an additional framelock cable master connector to the framelock cable
daisy-chain/stereo connector (
b. Connect the new slave cable connector to the next graphics board to be
framelocked. Stereo glasses may be attached to the final daisy-chain/stereo
connector.
Note – The Sun XVR-1200 graphics accelerator supports both tethered and wireless
stereo glasses. For wireless stereo glasses, connect the transmitter DIN7 connector to
the Sun XVR-1200 graphics accelerator stereo/framelock DIN7 connector or to the
framelock cable daisy-chain/stereo connector.
48 Sun XVR-1200 Graphics Accelerator Installation and User's Guide • July 2004
1 2
OUT
Sun XVR-1200 Graphics Accelerator Stereo/Framelock Connector
).
FIGURE 6-5
IN
).
FIGURE 6-5
).
FIGURE 6-4
Stereo/framelock (DIN7)