Operation - MTD I 21 Instruction Manual

EN
7 Ignition lock (depending on model)
Ignition lock
Fig. 5a
Starting: Turn key to the right
running, then release. Key is turned to
Stopping: Turn the key to the left, to
Ignition lock with OCR function (depending on
model)
Fig. 5b
This ignition lock features an OCR function
(= user-controlled mowing in reverse gear).
Starting: Turn key to the right
running, then release. The key at
allows mowing in the drive direction.
OCR position: Turn key to left from the normal
position to reverse mowing position
press the switch (1). The indicator light (2) comes
on and indicates to the user that the device can
now mow in reverse and forward gear.
Stopping: Turn the key to the left, to
8 Throttle
Set engine speed continuously.
Fast engine speed =
Slow engine speed =
9 Choke (depending on model)
To start a cold engine, pull the choke (9a) or set
the throttle to position
10 Fuel cap
Refuel
11 Oil filler neck
Fill up the oil and check the oil level
12 Battery
13 Can holder
14 Trailer coupling

Operation

Follow the instructions in the engine handbook!
Danger
Risk of injury
No person, especially children, and/or animals
should be allowed to stand close to the mower while
it is in use. They could be injured by stones or simi-
lar objects that might be thrown out.
Children must never be allowed to operate the
mower.
Be particularly careful when mowing in reverse gear
(devices with OCR switch). There must be nobody in
the working area of the unit.
Never empty the grass catcher attachment while the
cutter deck is running.
While emptying the grass catcher attachment, you or
other persons may be injured by ejected clippings.
When mowing on steep slopes, there is a risk of the
mower tipping over and you could be injured as a
result. Do not drive across the face of a slope, but
only straight up and down. The device should not
be driven on slopes with a maximum incline greater
than 20%. Do not turn the mower round while you
are still on the slope.
12
until the engine is
.
.
until the engine is
(normal)
.
.
.
(9b).
If the ground is wet the mower could slip due to
reduced traction and overturn. Only cut the grass
when the ground is dry.
Excessive speed can increase the risk of an
accident.
When mowing closed to the lawn edges, maintain
a safe distance at all times e.g. close to particularly
steep slopes, trees, bushes and hedges.
Pay particular attention when you are travelling in
reverse while mowing at the same time.
Inspect the ground on which the device is going to
be used and remove any loose objects that could be
picked up and thrown out again by the device.
If the cutter strikes a foreign object (e.g. stone) or if
the mower starts vibrating unusually:
Immediately switch off the engine. Before continuing
and
to use the device, have it checked for damage by a
specialist workshop
When rotary mowing, never stand in front of the
grass discharge openings.
Never place your hands or feet on or under rotating
parts.
Switch off the engine and remove the ignition key
and the spark-plug connector before loosening
obstructions or removing blockages from the dis-
charge channel.
Do not use the mower in adverse weather condi-
tions, e.g. if there is a risk of rain or a storm.
Danger of carbon monoxide asphyxiation
Run the internal combustion engine outdoors only.
Danger of explosion and risk of fire
Petrol vapour is explosive and petrol itself is
extremely flammable.
Fill up will petrol before you start the engine. Do not
remove the fuel cap while the engine is running or
if it is still hot. Fill the fuel tank only after the engine
has been switched off and allowed to cool down.
Prevent naked flames and spark formation, and do
not smoke. Only refuel the device outside. Do not
start the engine if any petrol has been spilt. Push the
device away from the area where the petrol was spilt
and wait until the petrol fumes have evaporated.
To prevent a fire hazard, keep the following parts
free from grass and leaking oil: Engine, exhaust, fuel
tank.
Danger
Injury hazard due to defective device
Do not operate the mower if it is not in perfect work-
ing order. Before operating the unit, always carry out
a visual inspection. Pay particular attention to safety
devices, the cutting mechanism and its supporting
brackets, operating controls and threaded connec-
tions, and check that they are not damaged and are
securely attached.
Replace damaged parts before operating.
Danger
Risk of injury
While the engine is running or hot, do not check,
inspect or service/adjust the mower.
Operation