Pultec Latency; Pultec Eqp-1A Screenshot; Pultec Eqp-1A Controls - Universal Audio Ampex ATR-102 Manual

Pultec Latency

The Pultec and Pultec-Pro plug-ins introduce an additional 13 samples of de-
lay due to upsampling when the session sample rate is below 100 kHz. This
additional latency does not occur at sample rates above 100 kHz. You may
enter a value of 13 in the "Samples" parameter in DelayComp or TrackAdv
to compensate. See Chapter 9 "UAD Delay Compensation" in the UAD Sys-
tem Manual for more information.
Note:
cation supports full plug-in delay compensation throughout the signal path, or
when it is used on outputs.

Pultec EQP-1A Screenshot

Figure 98. The Pultec EQP-1A Program Equalizer plug-in window

Pultec EQP-1A Controls

The EQP-1A can control three frequency ranges simultaneously, using three
groups of interacting parameters.
The first group controls the low frequencies and has three controls: boost, at-
tenuation, and frequency select. The second group controls the high frequen-
cies and has three controls: boost, bandwidth, and frequency select. The third
group also controls the highs and has two controls: attenuation amount and
frequency select.
The placement and grouping of the sections and their related controls are
shown in
UAD Powered Plug-Ins Manual
Compensating for Pultec and Pultec-Pro is not required if the host appli-
Figure 99 on page 326.
- 325 - Chapter 37: Pultec and Pultec-Pro