Little Labs Vog Parameters - Universal Audio Ampex ATR-102 Manual

cies above remain intact. The higher the amplitude of the peak resonance
frequency, the more you cut off the mud below, effectively performing two
functions at once. A dedicated "flat" button allows you to quickly audition
A/B comparisons.
The VOG is intended for mixing, mastering, post-production sweetening,
In Use
sound design, and audio restoration. Use it to easily simulate proximity effect
for adding chest resonance and "heft" to vocals. Simple adjustments will also
yield enormous sounding drums — just like tweaking the tension of a drum-
head. Or, completely transform the tonal characteristics of electric bass tracks
— for example, go from a solid body sound to a chambered body sound in
seconds. The VOG's flexibility makes it the right choice on a wide range of
musical sources; it's the perfect way to tune the low end of any mix for incred-
ible detail and punch.
Unlike the original hardware (which is monophonic), the plug-in enables ste-
Stereo
Functionality
reo use with one control set, providing perfectly matched stereo response.
When the plug-in is used in mono-in/stereo-out and stereo-in/stereo-out con-
figurations, the controls affect both the left and right signals.

Little Labs VOG Parameters

Amplitude adjusts the amount of the effect. Increasing the
Amplitude
control boosts the gain of the frequencies determined by
the Frequency and Center controls.
Note:
0 – 10, are arbitrary and do not reflect a particular dB
value.
Frequency
page
UAD Powered Plug-Ins Manual
The control values for Amplitude, which range from
This control adjusts the target frequency of the effect. Fre-
quencies above the current setting are boosted by the
amount set with the Amplitude control. Frequencies below
the current setting are attenuated by –24 dB per octave.
The available frequency range is determined by the Cen-
ter button settings, and are shown in
185.
- 184 -
Table 16 on
Chapter 19: Little Labs VOG