Table of Contents
Advertisement
Note:
mendations as guidelines and feel free to experiment with the various posi-
tions of the headroom switch regardless of the audio source. If it sounds
good, use it!
The UAD Neve 33609/33609SE includes a bank of factory presets. These
Factory Presets
presets can be useful starting points for your particular source audio.
The factory preset names begin with MSTR, BUSS, or TRAK. These indicate
the setting of the headroom parameter. (14 dB, 18 dB, and 22 dB respec-
tively).
Mastering (MSTR) presets are optimized for mixed program material that is al-
ready at a relatively high level.
Buss/group (BUSS) presets are optimized for subgroups of audio, such as a
drum group or vocal group. This type of application often has lower levels
than full mixes, but higher levels than a track insert.
Track (TRAK) presets are optimized for track inserts where signal levels typi-
cally aren't as hot as groups or outputs.
The preset names are guidelines and not rules. In many cases, you can use
any preset on any source with good results. You will probably need to adjust
the threshold and/or gain controls to obtain the optimum results with your par-
ticular source audio.
The Power switch determines whether the plug-in is active. This is useful for
Power
comparing the processed settings to the original signal, or to bypass the plug-
in to reduce the UAD DSP load (load is not reduced if UAD-2 DSP LoadLock
is enabled). Toggle the switch to change the Power state; the switch is illumi-
nated in red when the plug-in is active.
Note:
compare the enabled/disabled state.
UAD Powered Plug-Ins Manual
Keep in mind there are no hard and fast rules. Use the above recom-
You can click-hold the power switch then drag it like a slider to quickly
- 243 -
Chapter 26: Neve 33609 Compressor
Hide quick links:
Advertisement
Table of Contents
