Ambience Filters - Universal Audio Ampex ATR-102 Manual

Ambience Filters

The Ambience Filters (EQ) provide for frequency adjustments to the ambient
portion of the signal. These controls do not affect the direct (dry) portion of the
signal.
The Ambience Filters consist of one Low Cut filter, one High Cut filter, and a
single-band parametric bell filter.
Note:
cover Enable switch is engaged.
Refer to
Figure 89. Ambience Filters controls
EQ Enable The EQ switch enables/disables the Ambience Filters. This switch can only be
engaged when the Recover Enable switch is engaged.
The Low Cut and High Cut filters have a slope of 12 dB per octave. Each Cut
Cut Filters
Filter can be independently disabled by setting it to the OFF position (the de-
fault value).
Low Cut
The available range is 20 Hz to 1 kHz.
High Cut
The available range is 5 kHz to 20 kHz.
UAD Powered Plug-Ins Manual
Controls in the Ambience Filters section have no effect unless the Re-
Figure 89 below for the controls in this section.
- 289 - Chapter 33: Precision K-Stereo Ambience Recovery