Strong SRT40FC4003 User Manual page 65

Press OK to adjust. After finish your adjustment, press OK to save and return to the previous menu.
Below items depend if they are available of select input source. Use INPUT to select another source.
5.4.1 Auto Tuning
Press pq to select Auto Tuning, select the Scan Type and proceed with OK.
5.4.2 Dish Setup
If you use DVB-S/S2 as input source, the Dish Setup menu allow you to set you satellite and belonging
settings as DiSEqC port and LNB type. Afterwards you may start the Auto Tuning or Manual Tuning by
selecting with EPG button the wanted transponder.
5.4.3 DTV Manual Tuning (in DVB-T mode only)
Search and store programmes manually. Press pq to select DTV Manual Tuning. Then press OK to enter
the sub-menu.
Press t u to select a Channel No., and then press OK to start the search. The search stops when a
programme is found and this programme will be stored in the current channel position. If you want to
stop the search, press MENU.
5.4.4 ATV Manual Tuning (in DVB-C mode only)
First select the source type of ATV. Then in the Channel menu, select ATV Manual Tuning and press OK to
access. Highlight and press pq to select Storage To 1 (maybe other number), Sound System and Channel
No.. Then select search and press OK to start the search. Press u for the unit to search towards higher
frequency. Press t for the unit to search towards lower frequency. The search stops when a programme
is found and this programme will be stored in the current channel position. If you want to stop the
search, press MENU.
Current CH
Colour System
Sound System
Fine-Tune
Search
5.4.5 Channel extra settings
Programme Edit
Signal Information
Cl information
Channel list
Schedule List
Software Update (USB)
Set the channel number
Select the colour system (Available: AUTO, PAL, SECAM)
Select the Sound system
Adjust the frequency of the channel
Start the channel search
Edit the programmes. You can press the COLOUR BUTTONS on the remote
control to skip programmes, rename and delete programmes or move
programmes, and add programmes to the favourite list by pressing FAV.
Showing the information of current DTV channel. Only available with DTV
signal.
Enables the user to watch and change settings of CAM modules and check
values from inserted smart card.
Select which channel list you like to see if you press on LIST button. Select
between Main List or Favorite List
Press pq in the Channel. Select Schedule List, then press OK to enter the sub-
menu. Use the COLOUR BUTTONS to modify your settings.
Press OK and use t u to select Yes if you want to update the software or No
to go back to the main menu. For more information see also chapter 6.2.5.
11