Table of Contents
Advertisement
Quick Setup
The PowerSpace+ Configuration Utility Quick Setup is a wizard-based tool that guides you through the
initial configuration of your system.
IMPORTANT: All inputs, outputs, and
must be configured, the firmware must be up to date, and any additional amplifier settings, such as
70/100 V Hi-Z output voltage
the wizard. These items are located on the
In addition, the Network page of the Settings tab allows you to configure Internet Protocol (IP) settings
for the network by selecting either DHCP (default setting) or Static in the IP Configuration toggle.
Note: You are not required to use Quick Setup to configure your system. Instead, you can click
Configuration in the left navigation panel to open the
CAUTION: Running the Quick Setup wizard will reset current system settings. Except for Settings tab
configurations, any previously performed system configurations will be lost.
Starting Quick Setup
The Quick Setup wizard presents system configuration tasks in a logical sequence that mimics typical
workflow to facilitate system configuration.
Note: The amplifier automatically enters Standby mode when you start the Quick Setup wizard.
When configuration is complete, you must turn on the amplifier by either pressing the front panel
power button or disabling
To start the Quick Setup wizard:
1. In the bottom of the left navigation pane, click Quick Setup.
The Welcome page opens and reminds you to ensure that all inputs, outputs, and I-Share jumpers
(if required) are connected and that configuration is complete on the Settings tab.
Note: If you have not already configured these settings, click the Settings tab link on the Welcome
page. When you are finished configuring the settings, click Quick Setup again to return to the wizard.
2. In the lower-right corner of the Welcome page, click Continue.
A new page opens with a warning that: "All current configuration data will be DELETED upon
pressing continue."
Note: Settings tab configurations are not deleted when you run Quick Setup.
3. Click Yes, Continue to proceed with configuration using the Quick Setup wizard (or click No, Back to
return to the previous page).
Signal Flow
The
page opens.
Note: You can click the Back button at any time while using the wizard to return to the previous wizard
page, or you can click Exit (at the bottom of the left navigation pane) to leave the wizard. When you click
Exit, a dialog box appears stating, "Your progress will be lost. Are you really sure that you want to exit?"
Click OK if you want to exit or click Cancel to continue using the wizard.
Bose PowerSpace+ Configuration Utility User Guide
I-Share jumpers
or enabling
Auto Standby
Settings
Standby mode
on the
Summary
(if required) must be connected, network settings
mode, must be configured before initiating
tab.
Configuration
tab.
page of the Dashboard tab.
- 4 -
Advertisement
Table of Contents
