Setup - Rear-Panel Controls - Bose Professional FreeSpace IZA 190-HZ Installation And Operating Manual

Setup and Operation
Setup – Rear-panel controls
FreeSpace IZA 190-HZ
r
FRONT MIC
FreeSpace IZA 250-LZ
r
Amplifier mode DIP switches
.
• PAGE/MIC NORMAL – BYPASS MASTER
Determines if page input source will follow the master level output or can be set at a fixed output level to
ensure announcements are heard� When set to BYPASS MASTER use the respective input gain controls to
adjust the volume level of each microphone�
• OUTPUT MONO – OUTPUT STEREO
Determines if stereo input sources will be output in mono or stereo via loudspeaker connectors and AUX OUT
RCA connectors� Using this switch in a mono position will help provide sufficient gain for single-input devices�
Mono switch position will also sum stereo inputs for loudspeaker applications where stereo is not desired�
Note: On the IZA 250-LZ amplifier, OUTPUT 1 is the left channel and OUTPUT 2 is the right channel when set
to OUTPUT STEREO� On the IZA 190-HZ, the left channel is routed to the loudspeaker output when set to
OUTPUT STEREO�
• FRONT MIC MIX – FRONT MIC DUCK
Determines if front-panel microphone input will be mixed in with music source or if the music output level will
be automatically lowered ("ducked") when someone speaks into microphone�
• AUX OUT EQ – AUX OUT FLAT
Determines if AUX OUT will have selected loudspeaker EQ preset applied to it or not� Allows for optimization
of FreeSpace FS2C/SE/P and FS4CE/SE loudspeakers when used with additional zone amplifiers�
Loudspeaker EQ preset switch
3
Provides loudspeaker equalization presets designed to optimize the performance of Bose Professional
FreeSpace FS2C/SE and FS4C/SE loudspeakers� A high-pass filter (HPF) setting is also available for use with any
passive loudspeakers� The high-pass filter is set at 60 Hz for the IZA 190-HZ and at 40 Hz for the IZA 250-LZ�
The selected EQ preset (190-HZ: HPF (60 Hz), FS2C/SE/P, FS4CE/SE; 250-LZ: FLAT, FS2C/SE/P, FS4CE/SE)
can be sent to an additional zone amplifier via AUX OUT if "AUX OUT EQ" is selected with the corresponding
mode DIP switch�
Page input GAIN control
$
Allows for fine-tuning page input levels� If the front-panel INPUT CLIP indicator is red, reduce the input gain�
The adjustment range is 0 dB to +50 dB�
Line input GAIN control
/
Allows for fine-tuning of INPUT A/B levels� If the front-panel INPUT CLIP indicator is red, reduce the input
gain� The adjustment range is –20 dB to +20 dB�
Output TRIM control
1
Allows for attenuating individual loudspeaker outputs relative to the Master Level� The adjustment range is
–20 dB to 0 dB� This feature is helpful when one output is powering loudspeakers that need to be set at a
lower volume level than loudspeakers on other outputs – including the outputs of an additional zone amplifier�
26 Installation and Operation
e
FRNT MIC
MIX DUCK
q
e
q
w
FS2C/
SE/P
FS4CE/SE
t
w
FS2C/
SE/P
FS4CE/SE
t
BoseProfessional.com
English