Table of Contents
Advertisement
Quick Setup: Outputs
The Outputs pages in Quick Setup allow you to specify the number of outputs that are installed in
your system and configure them.
Note: PowerSpace+ amplifiers allow a maximum of four outputs.
To configure outputs using Quick Setup:
1. The first Outputs page asks, "How many outputs are in your system?" Use the up and down
arrows or type directly in the text box to specify the number of outputs in your system, and
then click Continue.
2. On the next Outputs page, enter a name for the output in the in the Label x text box.
3. Select the physical output channel from the Output Channel drop-down list.
4. Click the I-Share toggle (if available) if you want to enable I-Share and create an output channel
pair. I-Share output delivers twice the power level (into low-impedance (2-4Ω ) or high-impedance
(70/100V) loads) by combining the current of two output channels (channels 1 and 2, or 3 and 4).
I-Share reduces the number of available outputs because it pairs output channels.
IMPORTANT: You must ensure that I-Share jumpers are connected before enabling I-Share output
configuration mode. To view a diagram of how to wire an output pair for I-Share mode, see
Appendix B: Output and I-Share
Note: The I-Share toggle becomes available after the Output Channel is specified, and only if the
channel to be paired with the specified channel is available. The allowable channel pairings are
channels 1 and 2, or channels 3 and 4.
5. Select an EQ from the Speaker EQ drop-down list. This setting allows you to utilize preconfigured
equalization settings (presets) for Bose®loudspeakers, specify Flat EQ, or configure Custom
EQ settings.
6. Click the Polarity toggle to set the polarity of the signal to either positive (+) or negative (-),
also referred to as non-inverted and inverted, respectively.
Note: Polarity is positive (+) by default.
7. Click Continue.
Note: Repeat this procedure for each output in your system. The
opens after you have finished configuring all outputs and clicked Continue.
PowerShare®Configuration Utility User Guide
Wiring.
- 7 -
Listening Areas
(Routing) page
Advertisement
Table of Contents
