Appendix C: Controlcenter Analog Zone Controller Dip Switch Configuration; Cc-1 Controllers - Bose Professional PowerSpace+ Series User Manual

Bose PowerSpace+ Configuration Utility User Guide
Appendix C: ControlCenter Analog Zone Controller DIP
Switch Configuration
When connecting to a PowerSpace+ amplifier, use the following DIP switch settings to configure Con-
trolCenter analog zone controllers.
Up to four controllers can be connected directly to an amplifier's ControlCenter RJ-45 connector by
daisy-chaining controllers, or by using the Bose ControlCenter CV41 4-to-1 Converter.
The CC-1 DIP switches assign an ID that must match the ID of the controller that is assigned to the listen-
ing area in the UI. Each CC-1 controller requires DIP switch 3 to be ON. Only one of the DIP switches 5, 6, 7,
or 8 must be ON to match the ID assigned to the listening area in the UI. Set DIP switch 5 to ON for ID 1,
DIP switch 6 to ON for ID 2, DIP switch 7 to ON for ID 3, or DIP switch 8 to ON for ID 4.

CC-1 Controllers

One CC-1 controller:
This single CC-1 is configured as ID 1.
Two CC-1 controllers:
CC-1 #1 is configured as ID 1 and CC-1 #2 is configured as ID 2.
Three CC-1 controllers:
CC-1 #1 is configured as ID 1, CC-1 #2 is configured as ID 2, and CC-1 #3 is configured as ID 3.
Four CC-1 controllers:
CC-1 #1 is configured as ID 1, CC-1 #2 is configured as ID 2, CC-1 #3 is configured as ID 3, and CC-1 #4 is
configured as ID 4.
- 37 -