Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for meitav-tec TAT-SUPER
Summary of Contents for meitav-tec TAT-SUPER
- Page 1 Room thermostat TAT-SUPER Owner’s manual and Technician settings...
- Page 2 Index 1. Owner’s Manual………………………………………………………………………………………….………… 3-5 1.1 Turning the unit On or Off ………………………………………………………………………………..……. 3 1.2 Adjusting the set-point temperature ……………………………………………………………………..…… 3 1.3 Selecting system mode …………………………………………………………………………………..……. 3 1.4 Selecting fan speed…………………………………………………………………………………………….. 3 1.5 Enabling or disabling “fan on demand” option …………………………………………………………..….. 4 1.6 Timer ………………………………………………………………………………………………………..……...
- Page 3 1. Owner’s Manual 1.1 Turning the unit On or Off Press the [On/Off] button to turn the unit On. The word “ON” will appear on display. Press the [On/Off] button again to turn the unit Off. Unit OFF Unit ON The word “OFF”...
- Page 4 1.5 Enabling or disabling “fan on demand” option Press and hold the [Fan] button to enable or disable fan on demand. When enabled, the fan will run only with demand for cooling or heating. The fan icon on the bottom left side if the display will flash. Notes: - Fan on demand cannot be enabled when the system mode is set to fan only.
- Page 5 2. Installation instructions The thermostat is designed for flush mounting in the room to be controlled. It should be located where the occupant can easily read the LCD display and use the controls. If the built in temperature sensor is being used the unit should be placed where the temperature is representative of the general room conditions.
- Page 6 4. DIP switch configuration IMPORTANT! Before making any changes in the DIP switch disconnect power from the unit. The DIP switch is located on the side of the thermostat, next to the Switch Switch T1,0 and IN1,0 terminals. Default Enable Auto mode Disable Auto mode Display set-point only Normal temperature display...
- Page 7 6. Technician settings 6.1 Enter technician settings Adjust the set point temperature to 10°C/50°F and wait until display stops flashing. Press and hold the [Mode] button (7 sec.) to enter technician settings. Press the [Mode] button to proceed to the next parameter. Press the [Fan] button to return to the previous parameter.
- Page 8 6. Technician settings (cont.) 6.11 Input IN1,0 polarity (for remote off switch or 6.16 Economy set point for cooling remote economy switch) Range: 10...30°C/50...86°F, “PC” – Normally close (triggered when opened). Default 30°C/86°F. “PO” – Normally open (triggered when closed). Economy set point for IN1,0...
Need help?
Do you have a question about the TAT-SUPER and is the answer not in the manual?
Questions and answers