Maintenance - Kelvinator KWH53CRF Manual

Maintenance

Air Filter
The ai lter behind the inlet grille should be checked and
cleaned at least once every 2 weeks (or as necessary) to
maintain optimal performance of the air conditioner.
Removing the ai lter
1 The grille can be opened from the bottom for easy
maintenance after installation.
2 Open the inlet grille by pulling on the openings in the
bottom of the grille
3 Pull the tab slightly to release th
forward to remove it.
4 Clean th lter with warm soapy water. The water should
be below 40°C to prevent damage.
5 Rinse off and gently shake off any excess water from the
damage, do not dry in direct sunlight.
AUTO restart
During a power failure, the air conditioner will stop DRAIN
JOINT
completely. When the power is restored, the air conditioner
will start automatically with all the previous settings
preserved in the memory.
DRAIN
JOINT
lter. Pull th lter
RUBBER
PLUG
SEAL
RUBBER
PLUG
SEAL
The treatment of condensed water
1 Take out the drain pan and screws (provided within your
air conditioner accessories bag).
2 Install the drain pan at the bottom of the unit and secure
it with the screws provided.
3 Connect a suitable sized drain hose (not supplied) to the
drain outlet located on the underside of the drain pan.
drain
drain
pan
outlet
Drain plug (Cooling only models)
The drain plug is fitted from the factory to capture
condensed water to maximise the cooling efficiency of
this product. There may be some sound of splashing
water under some conditions. This configuration is used
for testing the capacity and efficiency of this product for
performance rating purposes.
The drain plug can be removed to drain water to a
specific location and/or reduce noise but drain plug
removal can reduce performance.
Kelvinator Air Conditioning remote control features/installation instructions 9
screw