Maintenance; Air Filter; Auto Restart; The Treatment Of Condensed Water - Kelvinator KWH20CRC User Manual

Maintenance

Air Filter

The air filter behind the inlet grille should be checked and
cleaned at least once every 2 weeks (or as necessary) to
maintain optimal performance of the air conditioner.
Removing the air filter
1 The Grille can be opened from the bottom for easy
maintenance sfter installation.
2 Open the inlet grille by pulling on the openings in the
bottom of the grille
3 Pull the tab slightly to release the filter. Pull the filter
forward to remove it.
4 Clean the filter with warm soapy water. The water should
be below 40 (degree symbol)C to prevent damage.
5 Rinse off and gently shake off any excess water from the
filter. Allow the filter to dry before replacing it. To prevent
damage, do not dry in direct sunlight.

AUTO restart

During a power failure, the air conditioner will stop DRAIN
JOINT
completely. When the power is restored, the air conditioner
will start automatically with all the previous settings
preserved in the memory.
DRAIN
JOINT
RUBBER
PLUG
SEAL
RUBBER
PLUG
SEAL

The treatment of condensed water

1 Take out the drain pan and screws (provided within your
air conditioner accessories bag)
2 Install the drain pan at the bottom of the unit and secure
it with the screws provided.
3 Connect a suitable sized drain hose (not supplied) to the
drain outlet located on the underside of the drain pan.
drain
drain
pan
outlet
Kelvinator Air Conditioning remote control features/installation instructions 9
screw