Check After Installation And Operation Test; Installation And Maintenance Of Hepa Filter - Kelvinator KSV80HRD Installation Manual

Check after installation and
operation test
Check after installation
Items to be checked
Has the unit been
fixed firmly?
Has you the refrigerant
leakage test been done?
Is thermal insulation sufficient?
Is water drainage satisfactory?
Is the voltage in accordance
with the rated voltage marked
on the nameplate?
Is the electric wiring or piping
connection installed correctly
and securely?
Has the unit been
securely earthed?
Is the power cord specified?
Is the inlet or outlet blocked?
Is the length of connection
pipes and refrigerant capacity
recorded?
Operation Test
1 Before Operation Test
a. Do not switch on power before installation is
finished completely.
b. Electric wiring must be connected correctly
and securely.
c. Cut-off valves of the connection pipes should
be opened.
d. All the impurities such as scraps and waste must be cleared
from the unit.
2 Operation Test Method
a. Switch on power and press "ON/OFF" button on the
remote controller to start the operation.
b. Press MODE button to select the COOL, HEAT (Not
available with Cooling Only models), FAN to check whether
the operation is normal or not.
10
Installation instructions
Possible malfunction
The unit may drop, shake or
emit noise.
It may cause insufficient
cooling (heating)
It may cause condensation.
It may cause water leakage.
It may cause electric
malfunction or damage
the unit.
It may cause electric
malfunction or damage
the parts.
It may cause electrical
leakage.
It may cause electric
malfunction or damage
the parts.
It may cause insufficient
cooling (heating)
The refrigerant capacity is
not accurate.
Installation and maintenance of
HEPA filter
Installation of HEPA Filter
1. Lift up the front panel from the two ends of it, as shown by the
arrow direction, and then remove the air filter
2. Attach the HEPA filter onto the air filter
3. Install the air filter properly along the arrow direction in the
diagram below, and then close the panel
Cleaning and Maintenance
Remove the HEPA filter and reinstall it after cleaning according to
the installation instruction. Don't use brush or hard things to clean
the filter. After cleaning, be sure to dry it in the shade.
Service Life
The general service life for the HEPA filter is about one year under
normal conditions.
Air filter
Air filter
HEPA filter
HEPA filter
Air filter
HEPA filter