Mounting and Installation
■Piping
•Before piping is connected, the product should be thoroughly blown out with air (flushing) or washed to
remove chips, cutting oil and solid foreign material from inside the piping.
•When screwing together pipes and fittings, etc., be certain that chips from the pipe threads and sealant do
not get inside the piping.
•Fit the raised part of the spacer to the recessed part (groove for the raised part) of the product.
•Tighten the retainer A with two hexagon socket head cap screws temporarily.
•Tighten the two hexagon socket head cap screws evenly using a hexagonal wrench.
•Refer to the table below for the tightening torque for the screws.
Applicable model
AMS20#
AMS30#
AMS40#
AMS60#
Caution
Hexagonal wrench socket size nominal value
2 mm
3 mm
4 mm
-23-
Tightening torque
0.36±0.036 N•m
1.2±0.05 N•m
2.0±0.1 N•m
No.PF※※-OMA1007