Power Up - GE ApexPro Service Manual

Power up

3-20
Installation: Power up
127(
ApexPro Telemetry Server power supplies automatically adjust to input power
sources within the specified limits. See
1. Plug the power cord into the power cord receptacle in back of the ApexPro
Telemetry Server.
Power Supply
Switches
2. Plug the 3-pronged ApexPro Telemetry Server power cord into an approved
activated UPS device.
3. Switch both ApexPro Telemetry Server power supply switches on. The power
supply status LEDs are green when the power supplies are properly activated.
4. Press and momentarily hold the power switch on the front of the ApexPro
Telemetry Server. The ApexPro Telemetry Server starts up in normal user
mode.
127(
To interrupt the normal startup procedure and log into the ApexPro
Telemetry Server as a different user, hold down the Shift key during
ApexPro Telemetry Server
2001989-178
"Technical Specifications"
BACK PANEL
Power Supply
Status LED
Power Supply
Status LEDs
Power Cord
Connector
on page A-3.
Alarm Reset
Button
136A
Revision C