Replacing Batteries - Daikin homecontrols EKRRVATU1BA Installation And Operation Manual

The operating lock of the DHC Radiator
Thermostat can be activated and deactivated via
the ONECTA app.
7

Replacing batteries

If the symbol for empty batteries (
used batteries by two new LR6/mignon/AA batteries. You
must observe the correct battery polarity.
To replace the batteries of the accessory, proceed as fol-
lows:
1. Open the battery compartment (B) by pulling the
cover backwards and then down (see figure 7).
2. Remove the batteries.
3. Insert two new 1.5 V LR6/mignon/AA batteries.
Make sure that you insert them the right way
round (see figure 8).
4. Close the battery compartment (B).
5. Pay attention to the flashing signals of the LED
while inserting the batteries (see „8.3 Error codes
and flashing sequences" on page 26).
» After inserting the batteries, the accessory will
perform a self-test (approx. 2 seconds). After-
wards, initialisation is carried out. The LED will
light up orange and green to indicate that initial-
isation is complete.
Replacing batteries
) appears, replace the
23