Danfoss Adapter - Daikin homecontrols EKRRVATU1BA Installation And Operation Manual

Threaded connection with set screw:
•
1. Loosen the set screw.
2. Remove the thermostat dial (P).
After removing the old thermostat dial you can mount the
Radiator Thermostat with the union nut (E) to the radiator
valve (see figure 6).
If required, you can use one of the supplied adapters for
Danfoss valves (see „5.2.2 Danfoss adapter" on page
17) or the supplied support ring (see „5.2.3 Support
ring" on page 21).
5.2.2

Danfoss adapter

One of the provided adapters is needed to attach to Dan-
foss valves.
Be careful not to get your fingers caught between
the two halves of the adapter!
The RA and RAV adapters have been manufactured with
pre-tension in order to provide a better fit. Use a screw-
driver during installation if necessary and bend the adapt-
er open slightly in the vicinity of the screw (see following
figures).
Start-up
17