Table of Contents
Advertisement
Replacing batteries
8
Replacing batteries
If the symbol for empty batteries (
used batteries by two new LR6/mignon/AA batteries. You
must observe the correct battery polarity.
To replace the batteries of the accessory, proceed as fol-
lows
1. Open the battery compartment (B) by pulling it
down (see figure 3).
2. Remove the batteries.
3. Insert two new 1.5 V LR6/mignon/AA batteries.
Make sure that you insert them the right way round
(see figure 11).
4. Close the battery compartment.
5. Pay attention to the flashing signals of the LED
while inserting the batteries (see „9.3 Error codes
and flashing sequences" on page 30).
»
After inserting the batteries, the accessory will per-
form a self-test (approx. 2 seconds). Afterwards,
initialisation is carried out. The LED will light up
orange and green to indicate that initialisation is
complete.
26
) appears, replace the
Advertisement
Table of Contents
