Wan Load-Balancing - Grandstream Networks GWN70 Series User Manual

Status enable or disable the Static Routing
IP Address Specify the IP address
Subnet Mask Enter the Subnet Mask
Outgoing Interface Select the interface
Next Hop Specify the next Hop
When there are multiple routings in the network that can reach the same destination, the priority of routing rules
Metric can be adjusted by setting metric, and the packets will be forwarded according to the path with the smallest
metric.

WAN Load-Balancing

Multi-WAN port routers like Grandstream GWN7062 with dual WAN ports can load balance between the WAN ports for
networks with redundant internet connections. It reduces network downtime and makes the most out of each link.
To load balance between multiple WAN ports please follow the steps below:
1. Enable Dual WAN Port
The first thing to do is to make sure that Dual WAN Port is Enabled under Network Settings → WAN → WAN Port Settings.
2. Add Policy Routing
Navigate to Routing → Policy Routing and click on
member refers to an interface either WAN1 or WAN2, each interface will have a Priority from 1 up to 128, and the WAN with
the highest priority will be used the most, and also weight from 1 up to 10 which indicates the percentage of traffic that
should be sent to this WAN.
Priorities need to be the same value to make a load balancing upon weight.
Table 12: Static Routing
Figure 34: Enable Dual WAN Port
to add a Policy Routing, then add members where each