Table of Contents
Advertisement
Multiple Public IP
Address
○ IPv6 Settings
GWN70xx routers also support IPv6 configuration.
Please refer to the following table for IPv6 settings:
IPv6
Check "ON" to activate IPv6
● DHCPv6 : When selected, it will act as a DHCP client and acquire an IPv4 address automatically from the
● Static IPv6 : When selected, the user should set a static IPv6 address, Prefix Length, default Gateway and
Connection Type
● PPPoE (only when IPv4 PPPoE is enabled) : can be only used if PPPoE IPv4 is already enabled.
The default setting is "DHCPv6".
Static DNS
Check Static DNS then enter the Preferred DNS Server and the Alternative DNS Server.
Once enabled, relay IPv6 addresses to clients on the LAN side.
IPv6 Relay to VLAN
Note: This function will take effect only "IPv6 Relay from WAN" is enabled on VLAN.
○ WAN Port Settings
The GWN7062 supports dual WAN port setup, by default the fourth LAN port is configured as LAN but the user can enable
Dual WAN Port to make it as a secondary WAN port.
To access this page, please navigate to Network Settings → WAN → WAN Port Settings.
Please use with Port Forward function, so that you can access to router via public IP address.
Table 5: WAN Settings
Figure 24: WAN – IPv6 Settings
WAN Settings
DHCP server.
Preferred DNS Server.
Table 6: IPv6 Settings
Advertisement
Table of Contents
